Roll forming machine

时间：2020-05-15 点击次数： 79

Plate rim roller gxj-001

The rim rolling machine is used for the forming of the plate rim. After three rolls, the size required by the process is reached. Rim roll forming machine's main parts as follows: the fuselage, the spindle mechanism, guide wheel mechanism and hydraulic parts + the main shaft is made of alloy steel finishing). Has high fatigue strength, the spindle with up and down, dip Angle and function of 3 d before and after adjustment, the spindle by hydraulic motor driven by hydraulic system. | roll forming machine, planing machine, rolling machine, end cutting machine of hydraulic pressure oil pump station can match the corresponding power of oil cooler for oil temperature, however in the hydraulic oil tank of the hydraulic oil temperature control set arbitrary between 25 ℃, 35 ℃.

Plate rim rolling machine technical parameters

1. Rim diameter: 17.5~38"

2. Rim width: 7.5~20"

3. Spindle mounting die diameter: 200mm

4. Spindle mounting die length: 500mm

5. Number of rollers: 2;

6. Number of guide wheels: 2;

7. Diameter of side guide shaft: 90mm

8. Side guide stroke: 200mm

9. Spindle speed: 0-250 RPM;

10. The maximum distance between the center point of the upper and lower spindle: 462mm (the lower axis is in full drop state)

11. Minimum distance between the center point of the upper and lower spindle: 362mm (the lower shaft is fully raised)